Filter
Top Products
15
SECTION IV
SERVICE and PARTS INFORMATION
A. RESETTING THE MICROPROCESSOR
1. To reset the microprocessor, enter the following sequence into the keyboard (touch pad). The sequence
must be entered within a 3-second period: left 6 gallons, right 6 gallons, left 5 gallons, right 5 gallons, and
left 1/2 gallon (22.71 liters, 22.71 liters, 18.92 liters, 18.92 liters and 1.89 liters).
B. SERVICE
1. Service must be performed by a qualified trained technician, service agency. If service is required, contact
the reseller from whom the ADC equipment was purchased. If the reseller cannot be contacted or is
unknown, contact the ADC Service Department for a reseller in your area.
NOTE: When contacting the ADC Service Department, be sure to give them the correct model and
serial numbers so that your inquiry is handled in an expeditious manner.
C. PARTS
1. Replacement parts should be purchased from the reseller from whom the ADC equipment was purchased.
If the reseller cannot be contacted or is unknown, contact the ADC Parts Department for a reseller in your
area. Parts may also be purchased directly from the factory by calling the ADC Parts Department at (508)
678-9000 or you may FAX in your order at (508) 678-9447.
NOTE: When ordering replacement parts from the ADC reseller or the ADC factory be sure to give
them the correct model and serial numbers so that your parts order can be processed in an
expeditious manner.
Serial Data
Label Placement