Filter
Top Products
English 26
Replacing an Oven Light Each light assembly consists of a removable lens, a light bulb and a light socket
housing that is fixed in place.
1. Read the WARNING above.
2. Turn off power at the main power supply (fuse or breaker box).
3. Remove the lens by unscrewing it.
4. Remove the light bulb from its socket by unscrewing it.
5. Replace the bulb with a new 40 watt appliance bulb. Avoid touching the bulb
with fingers, as oils from hands can damage the bulb when it becomes hot.
6. Screw the lens back on.
7. Turn power back on at the main power supply (fuse or breaker box).
Before Calling Service
Use these suggestions before calling for service to avoid service charges
Troubleshooting Charts
The Cooktop
WARNING
• Make sure the appliance and lights are cool and power to the appliance
has been turned off before replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
• The lenses (if equipped) must be in place when using the appliance.
• The lenses (if equipped) serve to protect the light bulb from breaking.
• The lenses (if equipped) are made of glass. Handle carefully to avoid
breaking. Broken glass could cause an injury.
• Light socket is live when door is open
Service
Table 7: Cooktop Troubleshooting Chart
Cooktop Problem Possible Causes and Suggested Solutions
Cooking results are not what
was expected.
• The cooktop is not level. Adjust leveling legs on bottom of range.
• Cooking pan is not the appropriate size or type. See “Cookware Selection Guide”.
Water takes too long to boil • Time to boil can vary greatly depending on environmental conditions. See “Boiling
Water” on page 16 for tips to decrease time to boil.
Burners click continuously • Knob(s) are in the “light” position. Turn knobs to the ”OFF” position or to desired
flame setting.
Burners click intermittently • Moisture has accumulated inside the ignitor. Turn both front burners to the highest
setting for 15-20 minutes then turn to OFF.