Filter
Top Products
15
ASSEMBLY AND OPERATION OF YOUR WIZZ
®
PLANETARY MIXER continued
itself off. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E2” will flash on the LCD
screen and the buzzer will “beep” 3 times.
If this error occurs, turn the speed
control dial to the ‘Off’ position, switch
the appliance off at the power outlet and
unplug the cord. Wait at least 15 minutes
before restarting the mixer.
ELECTRONIC PROTECTION CUTOFF –
CURRENT OVERLOAD
The mixer is equipped with an electric
protection cutoff and will automatically
stop operating if the motor is stalled or
overloaded. This is normally a result of
excessive ingredients being processed
at one time. Should the mixer go into this
mode, the LED indicator band will flash and
the error message “E1” will flash on the LCD
screen and the buzzer will “beep” 3 times.
If this error occurs, turn the speed
control dial to the ‘Off” position, switch
the appliance off at the power outlet and
unplug the cord. Remove some of the
ingredients in the mixing bowl and then
restart the mixer.
DISASSEMBLING THE MIXER
1. When mixing is complete, turn the
speed control dial to the ‘Off/Stand by’
position, switch the appliance off at the
power outlet and unplug the cord.
2. Remove splash guard if assembled.
Separate pour spout then slide main
ring out of position.
3. Raise the mixer motor head by
depressing the tilt back button and lift
the mixer motor head up until it tilts
back and locks into the open position.
4. Remove the beater/dough hook/whisk
attachment by holding the mixer motor
head and pressing the attachment
upwards on the spindle. Turn the
attachment anticlockwise to release it
from the pin on the spindle.
5. Use a soft plastic spatula to remove
mixture from the beater, dough hook or
whisk attachment.
NOTE: When lowering or lifting the mixer,
always support the motor head with your
other hand to prevent from free-falling.
6. Remove the mixing bowl from the
indented bowl locking recess of the
mixer Base and turn anti-clockwise
until the bowl releases. Use a soft
plastic spatula to remove mixture from
the mixing bowl.
7. Lower the mixer motor head by
depressing the tilt back hinge button
and pushing the mixer motor head
down until it locks into the horizontal
(closed) position.
BEM800_IB_Issue_0110.indd 15 10/12/09 10:00 AM