Filter
Top Products
19
CLEANING AFTER USE
1. Always ensure the speed control dial
is in the ‘Off’ position, the mixer is
switched off at the power outlet and
the power cord is unplugged.
2. Remove the beater, dough hook or
whisk attachment and mixing bowl
from the mixer. Follow instructions in
the ‘Assembly and operation’ section
of this booklet
3. Wipe the mixer motor head and
mixer stand with a soft, damp cloth
then dry thoroughly.
Wipe any excess food particles from the
power cord. Wash the bowl, beater, dough
hook, and whisk in warm soapy water with
a soft cloth or they can be washed in the
dishwasher. Rinse and dry thoroughly.
NOTE: Do not use abrasive scouring
pads or cleaners when cleaning the
mixing bowl, flat beater, dough hook or
whisk as these may scratch the surface.
Also ensure that the attachments are
not soaked in water for extended periods
of time, for example several hours or
overnight, as this may damage the finish.
NOTE: Do not wash or immerse the
mixer motor head and mixer base in
water or any other liquid. Clean with a
soft, damp cloth and dry thoroughly. Do
not allow water or any liquid to enter the
gear system as damage may result.
SCRAPER BEATER
1. Wash the scraper beater in warm,
soapy water using a soft cloth or
a soft bristled brush. Rinse and
dry thoroughly.
2. The Scraper Beater can also be
washed in the dishwasher (top
shelf only).
3. A small bottle brush can be used to
clean inside the neck of the Scraper
Beater if needed.
STORAGE
Your Breville Wizz
®
Planetary Mixer
should be kept in a convenient position
on your kitchen bench top or in an
accessible cupboard.
Always ensure the speed control dial is
in the ‘Off’ position, the mixer is switched
off at the power point and the power cord
is unplugged.
Store the mixing bowl in the bowl locking
recess in the mixer Base.
Place the attachments inside the mixing
bowl and lower the mixer motor head into
the horizontal (closed) position.
The motor head cannot be taken off the
base for any purpose.
CARE, CLEANING AND STORAGE
BEM800_IB_Issue_0110.indd 19 10/12/09 10:00 AM