Filter
Top Products
DIAGRAM 1a: SILICONE SEAL - DETAILED OF DIAGRAM 1
25
Quad
®
processing blade, dough
blade, discs and storage lid
Hand wash the storage lid. Use the double ended
cleaning brush accessory to scrub stubborn
food off blades and discs and for the inside of
the processing blade central support. To avoid
accidental cuts, do not leave Quad
®
processing
blade or discs to soak in sudsy water. The Quad
®
processing blade, dough blade, discs and storage
lid can also be washed in the dishwasher (top
shelf only).
The small end of the double sided cleaning
brush can be used for cleaning small
crevices of the Quad
®
processing blade and
dough blade shafts.
Food stains and odours
Foods such as carrot may leave a stain on plastic
parts whilst other foods such as garlic may leave
a strong odour. To remove either, soak the parts
for 5 minutes in 2 litres of water with ½ cup
lemon juice added. Rinse and wash as normal.
Motor base
Wipe the motor base with a clean, damp cloth after
each use. Dry thoroughly with a soft, clean cloth.
Processing bowl and lid
Hand wash in hot, soapy water using a mild
detergent. Do not use a scourer or abrasive
cleaners as they will scratch the plastic surface.
Lid seal
Your Breville ikon™ Food Processor is equipped
with a silicone seal, located in a recess around
the outer rim of the food processor bowl lid, to
reduce leakage while processing larger volumes
of wet ingredients. The silicon seal is removable
for cleaning purposes. However, to ensure its
effectiveness, the silicone seal must be inserted
correctly.
Removing the seal
Pry the silicone seal out of the recess in which it
is positioned, using your fingers or non marking,
blunt implement such as the tip of the plastic
spatula provided, and gently pull it over the lower
edge of the lid. Once a section of the silicon seal
has cleared the lower edge of the lid, it should
come off with ease. Be careful not to over-stretch
the silicon seal as this may damage or break it.
Clean the silicon seal in warm water using a mild
detergent, rinse and dry thoroughly.
Installing the seal
Step 1
To ensure the silicone seal is inserted properly,
the ribbed side of the seal should sit against the
bowl and the smooth side should face out.
Step 2
The smooth side of the seal has a thick and thin
section. Ensure the thin section of the seal is
sitting on top of the thick section. See diagram 1a
Step 3
Once positioned correctly, place a small section
of the silicon seal into the recess it was removed
from, then, holding the seal in position with one
hand, gently stretch the remainder of the seal
over the lower edge of the lid and into the recess.
Ensure that the silicon seal aligns and sits wholly
within the recess around the outer rim of the food
processor bowl lid. See diagram 1.
Cleaning and Care
thin section of seal
SILICONE SEAL
DIAGRAM 1: SILICONE SEAL
thick section of seal
BFP650_IB_FA.indd 25 17/4/09 3:27:39 PM