Filter
Top Products
Rigging the Machine — The 23XL can be rigged as
an entire assembly. It also has flanged connections that
allow the compressor, cooler, condenser, and oil separator
sections to be separated to fulfill specific installation
requirements.
RIG MACHINE ASSEMBLY — See rigging instructions
in plastic envelope attached to machine. Also refer to rig-
ging guide (Fig. 4 and 5), physical data in Fig. 6 and 7, and
Tables 1-6. Lift machine only from the 3 points indicated in
the rigging guide. Spreader bar must be used. Each lifting
cable or chain must be capable of supporting the entire weight
of the machine.
Lifting machine from points other than those specified
may result in serious damage and personal injury. Rig-
ging equipment and procedure must be adequate for
machine weight. See Tables 1-6 for machine weights.
NOTE: These weights are broken down into component
sections for use when installing the unit in sections. For
complete machine weight, add all section components
together. Total machine weight (Table 6) is also sten-
ciled on the cooler and condenser sections.
FRONT VIEW
REAR VIEW
Fig.3—Typical 23XL Installation (Frame 4 Machine)
1—Compressor Nameplate (Hidden)
2—Power Panel
3—Local Interface Display (LID) Control Center
4—ASME Nameplate, Cooler
5—Cooler
6—Vessel Separation Feet
7—Economizer Float Valve Access Cover
(Hidden)
8—Refrigerant Charging Valve
9—Economizer
10 — Oil Filter Assembly (Hidden)
11 — ASME Nameplate, Economizer
12 — Typical Waterbox Drain Port
13 — Take-Apart Rabbet Fit Connector
14 — ASME Nameplate, Condenser
15 — Cooler Supply/Return End Waterbox Cover
16 — Condenser Temperature Sensors
17 — Cooler Relief Valve
18 — Unit Mounted Starter (Option)
19 — ASME Nameplate, Oil Separator
20 — Oil Separator Relief Valves
21 — Oil Separator
22 — Oil Charging Valve
23 — Condenser Isolation Valve (Option or
Accessory)
24 — Service Valve
25 — Cooler Refrigerant Isolation Valve
26 — Condenser Relief Valves and Oil Filter
27 — Float Chamber
28 — Poppet Valve Assembly
29 — Motor Cooling Isolation Valve
30 — Condenser
31 — Condenser Supply/Return End
Waterbox Cover
32 — Cooler Temperature Sensors
33 — Machine Identification Nameplate
4