Filter
Top Products
11
Locate the center mounting hole. Remove and retain the
screw attached to the chassis beneath it.
Insert the tabs on the trim piece into the slots on the range.
Use the hex head screw (83023) removed from the side, a
Torx head screw removed from the kick panel and the hex
screws from the kit to attach the side panel to the range.
Three (3) hex head screws attach the side. One (1) Torx head
screw (83709) inserts through the end cap hole to attach
the top of the side panel. One (1) Torx head screw (83709)
inserts through a hole in the front panel to attach the bottom
of the side panel.
Reinstall the end cap.
Repeat steps 3 to 7 for the right side panel. NOTE: There is
an additional hex screw (83023) in the kit for the right side
panel because the center mounting screw is not reused as
with the left side (do not perform step 4).
5.
6.
7.
8.
3 Inch Side Panel Installation
Side Panel
Torx screw
Hex screw
Hex screw
Hex screw
Front panel
Torx screw
3 Inch Side Panel Kit Installation for Model
ER30DSR (continued)
With the door closed, reattach the kick panel to the range
by snapping the ball studs on the back of the panel into the
holes on the front panel of the range.
Open the door and reattach the kick panel top screws
removed in step 1.
9.
10.
Reattach kick panel
with existing screws
Space between
door and oven
opening
Installation Instructions