Filter
Top Products
12
Installation InstructionsInstallation Instructions
Removing the Oven Door
WARNING
Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
Do not lift or carry the oven door by the door handle.
•
•
To make the range easier to move, remove the door(s) to reduce
weight.
Open the door to its fully opened position.
Rotate the catch over the retaining arm on each hinge.
Lift the oven door to about a 15° angle from the vertical
position.
Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
1.
2.
3.
4.
Electrical Connection
WARNING
Wire the range only in compliance with local ordinances.
Do not turn on power to the range until instructed to
do so in the Verify Proper Operation section of these
instructions.
Improper connection of the electrical wiring can cause an
electric shock hazard and damage the appliance. Dacor
is not responsible for damages resulting from improper
installation.
The ground terminal (or lead) on the appliance must be
connected to a grounded, metallic, permanent wiring
system or grounding conductor.
Do not use an extension cord with this appliance. Such use
may result in fire, electric shock or other personal injury.
Do not install a fuse in the neutral or ground circuit. A fuse
in the neutral or ground circuit may result in an electric
shock hazard.
•
•
•
•
•
•
NOTE:
Freestanding model ER30D-C is wired for use in Canada and
comes from the factory pre-wired. If installing a pre-wired range,
skip to Gas Supply Connection on page 17.
IMPORTANT:
Make sure that the conduit or appliance cord is long enough
to allow the range to be pulled out for service without
disconnecting it from power.
Do not disconnect any of the wires inside the range electrical
box unless instructed to do so.
•
•
Door Gripping Points
Retaining Arm
Catch
Releasing the Door Hinges
Put slack in
electrical wiring
and gas line
Back of Range
Electrical Access Cover