Filter
Top Products
Back to Contents Page
VGA/Power Board
Dell™Inspiron™N5110ServiceManual
Removing the VGA/Power Board
Replacing the VGA/Power Board
Removing the VGA/Power Board
1. Follow the instructions in Before You Begin.
2. Remove the display assembly (see Removing the Display Assembly).
3. Follow the instructions from step 2 to step 11 in Removing the System Board.
4. Remove the hinge cover (see Removing the Hinge Cover).
5. Carefully ease the connectors on the VGA/Power board out of the slots in the base cover, and lift the VGA/Power Board off the base cover.
Replacing the VGA/Power Board
1. Follow the instructions in Before You Begin.
2. Align the connectors on the VGA/Power board with the slots on the base cover and place it on the base cover.
3. Replace the hinge cover (see Replacing the Hinge Cover).
4. Follow the instructions from step 6 to step 16 in Replacing the System Board.
5. Replace the display assembly (see Replacing the Display Assembly).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
VGA/Power Board
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.