Filter
Top Products
8. Using a plastic scribe, carefully pry out the palm-rest assembly along the rear edge and then ease the palm-rest assembly from the computer base
9. Lift the palm-rest assembly off the computer base.
Replacing the Palm-Rest Assembly
1. Follow the instructions in Before You Begin.
2. Align the tabs on the palm rest assembly with the slots on the computer base and gently snap the palm rest assembly in place.
3. Slide the touch-pad cable, power-button board cable, and hot-key board cable into the connectors on the system board and press down on the
connector latches to secure them.
1
power-button board cable
2
touch-pad cable
3
screws (4)
4
hot-key board cable
CAUTION: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.
1
plastic scribe
2
palm-rest assembly