Filter
Top Products
Back to Contents Page
Palm-Rest Assembly
Dell™Inspiron™N5110ServiceManual
Removing the Palm-Rest Assembly
Replacing the Palm-Rest Assembly
Removing the Palm-Rest Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the six screws that secure the palm-rest assembly to the computer base.
4. Turn the computer over and open the display as far as possible.
5. Remove the keyboard (see Removing the Keyboard).
6. Remove the four screws on the palm-rest assembly.
7. Disconnect the power-button board cable, touch-pad cable, and hot-key board cable from the connectors on the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
CAUTION: Pull on the plastic tab on top of the connectors to avoid damaging the connectors.