Filter
Top Products
Replacing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Place the display assembly in position and replace the four screws that secure the display assembly to the computer base.
3. Route the Mini-Card antenna cables through the routing guides.
4. Connect the Mini-Card antenna cables to the Mini-Card(s) (see Replacing the Mini-Card(s)).
5. Connect the display cable and touch-screen cable to the connectors on the system board.
6. Follow the instructions from step 2 to step 7 in Replacing the Palm-Rest Assembly.
7. Replace the two screws that secure the display assembly to the computer base.
8. Replace the battery (see Replacing the Battery).
Display Bezel
Removing the Display Bezel
1. Follow the instructions in Before You Begin.
2. Remove the top cover (see Removing the Top Cover).
3. Remove the display assembly (see Removing the Display Assembly).
4. Using your fingertips, carefully pry up the inside edge of the display bezel.
5. Remove the display bezel.
1
display assembly
2
screws (4)
3
display-cable connector
4
Mini-Card antenna cables (2)
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the display bezel.