Back to Contents Page
Module Cover
Dell™Inspiron™N5110ServiceManual
Removing the Module Cover
Replacing the Module Cover
Removing the Module Cover
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Loosen the captive screw that secures the module cover to the base cover.
4. Using your fingertips, release the tabs on the module cover from the slots on the computer base.
5. Lift the module cover off the computer base.
Replacing the Module Cover
1. Follow the instructions in Before You Begin.
2. Align the tabs on the module cover with the slots on the computer base and snap the module cover into place.
3. Tighten the captive screw that secures the module cover to the computer base.
4. Replace the battery (see Replacing the Battery).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
tabs
2
module cover
3
captive screw
CAUTION: To avoid damage to the computer, use only the battery designed for this particular Dell computer.