Filter
Top Products
Back to Contents Page
Display
Dell™Inspiron™N5110ServiceManual
Display Assembly
Display Bezel
Display Panel
Display Cable
Display-Panel Brackets
Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the two screws that secure the display assembly to the computer base.
4. Follow the instructions from step 3 to step 9 in Removing the Palm-Rest Assembly.
5. Disconnect the display cable and touch-screen cable from the system-board connectors.
6. Disconnect the Mini-Card antenna cables from the connectors on the Mini-Card(s) (see Removing the Mini-Card(s)).
7. Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.
8. Remove the four screws that secure the display assembly to the computer base.
9. Lift the display assembly off the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
NOTE: The touch-screen board is optional and may not be present in your computer.