Filter
Top Products
4
®
3. Remove the cooking pot and place food into the pot according
to the recipe or cooking chart (see pages 11, 13-19)
4. Position the pot into the appliance and place the lid onto the
Pressure Cooker and turn it clockwise (to the left) until the lid
is locked.
5. Turn the pressure regulator
knob on the top of the lid to
AIRTIGHT.
6. Set the cooking function based
upon the recipe or desired food setting.
See pages 13-19 for further instructions.
7. Press the
“Start” button to begin cooking.
8. When cooking is finished, the unit will beep 3 times. Let the
pressure drop on its own (called natural release) or turn the
regulator knob to EXHAUST (called quick release) until the
pressure is reduced.
CAUTION: When turning the knob to release pressure, hot
steam/liquid will be ejected.
NOTE: Press the “Warm/Cancel” button when cooking time is
complete, or to cancel and reset. Otherwise, the pressure cooker
will automatically switch to warm. Unless “Warm/Cancel” button
Before First Use
1. Remove all packing materials and literature.
2. Wash all removable parts in warm soapy water. Rinse and dry all
parts thoroughly. Wipe the outer housing with a clean damp
cloth. NEVER immerse the housing in water or any other liquid.
NEVER clean any parts in a dishwasher.
3. Make sure the rubber gasket is seated properly inside the lid. To
ensure the correct fitting, fill the removable cooking pot with
two-thirds water (Note: use the 3 cup mark on the inside of
the cooking pot); and run the unit for 15 minutes using DIY
Function (see page 8).
4. Release the pressure by turning the pressure regulator knob to
EXHAUST. The floating valve will drop.
5. Let the appliance cool to room temperature and then empty and
clean.
How To Operate Using Pressure Setting
Before using the pressure cooker each time, check to be sure that
the rubber gasket and the pressure regulator valve are clean and
positioned properly (see page 10).
1. The unit comes with a detachable cord. Plug the
cord into the unit first, then into a wall outlet.
The unit will beep and the display will show
“0.00”
2. Open the lid, holding the handle and turning it in
anti-clockwise direction (to the right) until the lid
will not move any further, then remove the lid
vertically.