Filter
Top Products
15
All gas connections used in this installation must comply with appropriate national
and local codes. The gas supply line must be the same size or greater than the
inlet line on the range. The gas connection is male 1/2” BSP and is situated 2.16”
(5.5 cm) from the right and 22” (56 cm) from the oor. Use the appropriate sealant
resistant to gas on all pipe joints.
This range can be used with Natural or LP/Propane gas. The range comes
shipped from the factory for use with natural gas.
For installations using propane, the fuel settings of the range must be adjusted by
the dealer, a licensed plumber, or another trained professional.
Proper fuel conversion is mandatory for the proper and safe use of the appliance.
It is the responsibility of the owner of the range or the dealer who sold it to ensure
this is done correctly.
VENTILATION
This range should be installed in accordance with the local regulations and used
only in a well ventilated space (do not use the range in your garage, basement,
room without windows, etc.)
The use of a gas cooking appliance produces heat and moisture in the room
in which it is installed. Ensure that the kitchen is well ventilated, keep natural
ventilation holes open or install a mechanical ventilation device. This range will
perform best when used with Fagor ventilation hoods.
Prolonged intensive use of the appliance may call for additional ventilation, such
as the opening of a window, or more effective ventilation, including but not limited
to increasing the level of mechanical ventilation where present.
MANUAL SHUT-OFF VALVE
A shut off valve does not come with this range. An appropriate valve should be
provided by the installer.
A manual valve must be installed in the gas line between the gas hook-up on the
wall and the appliance inlet in a location where it can be reached quickly in the
event of an emergency.
FLEXIBLE CONNECTIONS
When performing an installation with exible couplings or quick-disconnect
ttings, the installer must use a heavy-duty, AGA design-certi ed commercial
exible connector of at least 1/2” (1.3 cm) ID NPT (with suitable strain reliefs)
in compliance with ANSI Z21.41 and Z21.69 standards.
GAS CONNECTION
2.5