Filter
Top Products
Part # MPSM07 (03/24/08)Page 8
PREPARING THE OVEN FOR INSTALLATION
Legs and Casters
NOTE: If you will be installing an open base kit, please skip to
the next page and proceed with the steps listed under “Open
Base Assembly.”
1. (See Figure 1.). At the bottom end of each leg, install the
bullet foot insert or caster insert. The t of the insert to the
leg is intended to be snug, tap them lightly into place with
a mallet or rubber hammer.
Install two #5 x 1/4” self-drilling, thread forming screws
into each caster insert.
2. Screw a caster into the insert on each of the four legs.
The caster must be inserted at least three full threads to
properly support the oven. A 1” (25mm) open-end wrench
may be needed to properly install the casters.
OR
Using your ngers, screw the ends of the bullet feet into
the leg clockwise until they are at their shortest length.
3. Carefully tip and lower the oven onto its left side so you
can easily reach the bolt mounting locations in the base.
4. The four holes in the top of each leg or in the top plate of
double stack casters will match the bolt locations at each
corner of the oven base.
You will need four 3/8-16 x 1” hex head bolts and four 3/8”
at washers to mount each leg. Align the leg to one of the
matching bolt holes on the base and insert a bolt with
washer.
Install the remaining three bolts and nger-tighten all
four before using an 11/16” wrench to fully tighten them
all. Be sure to tighten all four bolts for each leg or caster.
When installing casters, make sure the two casters with
brakes are installed at the front of the oven.
5. Carefully return the oven to an upright position. Ensure
the two legs/casters that touch the oor rst when you
raise the oven are blocked and chocked so they do not slip
away.
6. It is very important to use the adjustable bullet foot
inserts in leveling the unit.
7. If you have installed casters, be sure to install the restraint
bracket on the lower left corner of the rear of the oven
using two #10 x 3/4” sheet metal screws.
Figure 1.
CASTER INSERT (4)
CASTER (4)
SCREW (2 PER CASTER INSERT)
FLAT WASHER (4 EACH LEG)
BOLT (4 EACH LEG)
FOOT INSERT (4)
LEG ASSEMBLY (4)
BOLT (4 EACH CASTER)
FLAT WASHER (4 EACH CASTER)
DOUBLE DECK CASTER (4)