Filter
Top Products
OVEN CONTROL, CLOCK AND
TMER
Clock To Set the Clock
The clock must be set for the
m
1.
Press the
automatic oven timing functions to
CLOCK
CLOCK pad.
work properly. The time of day
cannot be changed during a Timed
Bake or CLEAN cycle.
❑
2. Press the
A
INCREASE or
DECREASE pad to
set the time of day.
3. Press the CLOCK pad to start.
Timer To Set the Timer
The timer is a minute timer; it does
m
1. Press the TIMER
not control oven operations. The
TIMER
ON/OFF pad.
maximum setting on the timer is
ON/OFF
9
hours and 55 minutes.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a few seconds of releasing
the INCREASE or DECREASE pad.
The timer, as you are setting it,
will display hours and minutes.
“HR” will be in the display.
During the countdown, when the
timer reaches the last minute, the
display will change to seconds
only and a single beep will sound.
To Reset Timer
If “TIMER” is showing, press the
INCREASE or DECREASE PAD
until desired time is reached. If
“TIMER” is not showing, touch
TIMER ON/OFF pad first, then
follow the instructions above to set
the timer.
To Cancel Timer
Power Outage?
Press the TIMER ON/OFF pad
After a power outage, when power
until the word “TIMER” quits
is restored, the display will flash
flashing on the display (about
and time shown will no longer be
4 seconds).
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
All other functions that were in
operation when the power went out
will have to be programmed again.
End of Cycle Tones
The End of Cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the
CLEAWOFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the
CLEAWOFF pad for 10 seconds.