Filter
Top Products
PrecisionSwirl Module Operation
22 310554V
Setting Operation Modes
The PrecisionSwirl module has two operating states:
• Automatic mode — enables the PrecisionSwirl
orbital dispenser to be controlled by a remote signal
source, such as a robot control. Motor speed can be
controlled by a 0-10 VDC analog signal.
• Manual mode — enables the PrecisionSwirl orbital
dispenser to swirl when you press the
RUN/ENABLE button on the control assembly.
Swirling continues until the STOP button is pressed.
The PrecisionSwirl orbital dispenser is in an idle state
until you press the RUN/ENABLE button on the control
assembly. The only time the PrecisionSwirl orbital dis-
penser can swirl material is when the RUN/ENABLE
button is pressed in either Automatic or Manual mode.
When the STOP button is pressed, the PrecisionSwirl
orbital dispenser becomes idle and will not swirl mate-
rial.
The procedures in this section configure the module for
manual or automatic operation.
F
IG. 12
0/7%2
-/4/2&!5,4
25.
-!).
25.%.!",%
#/.42/,3%,%#4
!54/-!4)#
-!.5!,
-!.5!,30%%$#/.42/,
8030A
Material flow rate and “ON/OFF” flow are not con-
trolled by the PrecisionSwirl orbital dispenser.
These must be controlled by the other interfaces.
Contact your Graco Distributor for assistance.