Filter
Top Products
- 11 -
- 11 -
5 Programming
5.1 Preparation
• Connect the test receiver to the HF output or the test output of the head-end
station.
• Set the output channel / output frequency of the
cassette
(see page 20) and
adjust the TV test receiver to this channel.
• Switch on the modulator if necessary.
• Balance the output levels of the channel strips “A” and “B” if the difference in
level is ≥ 1 dB (see chapter “Modulator settings”, page 19).
• Measure the output levels of the analogue
cassettes
and tune them to a uni-
form output level using the appropriate level controls 2 (s. page 7).
5.2 Notes on the following programming procedure
– The parameters to be set are underlined (cursor).
– Connection C : Time-controlled channel selection
– Connection D : Decoding 2 stations with one CA module