Filter
Top Products
– 10 –
Attaching Control Box to Unload Section
1. For ease of control box installation, remove the detachable leg section on
the front leg of the unload section where the control box will be mounted by
removing the upper and lower ¼-20 hardware. This will allow the wires, which
are preinstalled in the control box, to pass by the leg assembly freely (Fig. 7).
REMOVE 1/4” - 20
HARDWARE
DETACHABLE LE
G
SECTION
Fig. 7
2. With the control box rotated 90 degrees, move the unload section to within
several inches of the center section behind the control box.
3. Maneuver the unload section so that the four 5/16-18 threaded studs on the
back of the control box protrude thru the mounting holes on the unload section.
4. Secure the control box to the unload section using four 5/16-18 nuts, lock
washers, and washers.
5. Once the control box is secured to the unload section remove the two shipping
hinges from the side of the control box by removing the two 5/16 bolts and
associated hardware from each hinge. The control box is now part of the unload
section.
6. Install two 5/16 round head screws in open holes of control box where shipping
hinges were removed.
7. Remove the hinges from the shipping braces by removing the cotter pins and
hinge pins.