Filter
Top Products
– 16 –
Installing the Flowback Pipe (Wash to Prewash Tanks)
Installtheowbackpipebetweenthewashtankandtheprewashtank(Fig.14).
MakesuretheowbackpipeisadequatelylubricatedwithO-ringlube(notsupplied).
Make sure O-rings are in their proper places on the coupling; two inside and one
ontheangeend.
WASH TAN
K
PREWASH TANK
FLOW BACK PIPE
Fig. 14
Installing the Drain Pipe
Install the drain pipe between the adjoining tank sections as follows:
1. Lubricate the molded drain T-connectors at each end of the drain pipe using
O-ring lube (not supplied). Do not use animal-, vegetable-, or petroleum-based
lubricants.
2. With a twisting motion, slide the pipe into one of the molded drain T-connectors.
3. Lift the other end, align it with the molded drain T-connectors and with a twisting
motion, slide the pipe until the drain pipe hits the stop in the tee (approximately
1-1/4” from the face of the tee).
Applying Master Drain Label
If the Master Drain assembly is not being relocated to the load end of the machine,
apply the Master Drain label to the panel located above the Master Drain handle.
The label is shipped with the machine in the Master Drain parts kit.
If relocating the Master Drain assembly to the load end, apply the Master Drain label
to the lower panel located above the Master Drain handle assembly.