Filter
Top Products
– 17 –
Relocating Master Drain to Load End (Only Machines Equipped with Auto Clean, Auto
Delime, & the ASR Section)
NOTE: If the dish machine is equipped with the Auto Clean and Auto Delime
features, but does not contain the ASR section, then the Master Drain assembly
must remain located at the unload end of the machine. With this conguration,
if the customer’s drain is located at the load end of the machine, then the
drain will need to be plumbed from the unload end back to the customer’s
drain in the eld.
If the installation requires the machine to be drained to the load end, the master
drain assembly will need to be relocated as follows:
1. Remove drain handle support bracket by removing the two bolts and associated
hardware located on the bottom side of the frame channels. The support bracket
may be discarded; however, retain the hardware removed for reassembly on
the load end.
2. Remove drain handle weldment by removing M12-1.5mm nut located at the
bottom of the drain assembly. Remove magnet retainer and magnet from drain
handle weldment and retain the nut, magnet retainer, magnet, and associated
hardware for reassembly on the load end. The drain handle weldment may now
be discarded.
3. Remove D.I.N. connector from master drain solenoid valve and remove drain
interlock switch from bracket securing it to the unload master drain platform.
Retain all hardware for use on load end platform.
4. Remove three bolts securing master drain assembly platform from bottom of
frame channels.
5. Slide platform and master drain assembly towards unload end of unit disengaging
the master drain assembly from the drain pipe extending from the dual rinse
tank and remove the platform and drain assembly from the unit.
For a L-R machine (steps 6-8):
6. Remove turned down threaded piece (00-949948) from drain tee at the unload
end and replace with NPT pipe plug shipped with the machine. 00-949948 can
be discarded. See Fig. 15.
00-949948
Fig. 15
7. Remove drain cap, clamp, and rubber hose connected to drain tee located at
load end of the unit.
8. Swapangedloadenddrainteewiththenon-angedrainteelocatedunder
the wash section.