Filter
Top Products
– 9 –
3. A hole for 1” trade size conduit is supplied at the lower right in the back of the machine (Fig. 3).
If necessary due to space requirements, remove the knockout and use a 45° tting.
Fig. 3
4. Install 1” trade size conduit and tting. Leave at least four feet of electrical line between wall
connection and machine. This allows machine to be pulled away from the wall for cleaning and/
or servicing.
5. Feed wires thru base of unit to front of unit. At least 24” and not more than 28” of the required
wire size must extend from the end of the conduit tting.
6. Make electrical connections according to wiring diagram supplied with the machine and secure
wires to the machine service connection. Keep excess wire in the base of the unit to a minimum.
7. Replace the left side panel, top of unit, and lower front panel. Re-install the three screws located
behind the door and the two screws at the bottom of the front panel.
DETERGENT AND RINSE AID
Use only commercial-grade detergents recommended by your chemical professional. Do not use
detergents formulated for residential dishwashers.
The detergent and rinse aid pump "ON" times are factory-set. If adjustments are required, contact your
local Hobart Service Ofce or your chemical supplier.
Place the detergent and rinse aid containers (which are obtained from an independent supplier) in a
location where the delivery tubes will reach them.
Remove the detergent bottle cap and put the red delivery tube in the detergent container.
Remove the rinse aid bottle cap and place the blue delivery tube in the rinse aid container.
Be sure to push the delivery tube standpipes completely to the bottom of each container. Check to
make sure there are no obstructions or kinks in the delivery tubes.
KNOCKOUT