Filter
Top Products
IMPORTANTSAFETY
INSTRUCTIONS
Anti-Tip Bracket (contd.)
Step 2
Anti-tip bracket installation
A. Wood Construction:
Floor: Drill a 14_pilot hote in
the center of each pre-marked
wood floor hole position (a nail
or awl may be used if a drill is
not available),
AND
.
Wall: Drill an angled 1/8"pilot
hole (as shown in Fig, 2) in
the center of each pre-marked
wall hole position (a nail or awl
may be used if a drill is not
available).
ATTACHMENT TO WALL AND FLOOR
Bracket
or
Wall
Plate
C. Concrete Construction:
1.
Hardware required:
4 each 1/4"x t t/2"lag bolt
4 each 1/2"OD sleeve
anchor
= Drill the recommended size
hole for the anchors into the
concrete at the center of each
pre-marked concrete floor and
wall hole position Install the
sleeve anchor into the drilled
holes and then install the lag
bolts through the bracket
DO NOT OVERTIGHTEN
THE BOLTS,
Step 3
Checking the installation
A. Complete the installation of
the range per the installation
instructions provided with it,
B. Check if the ANTI-TIP bracket is
installed and engaged properly
Remove the kick panel or storage
drawer and inspect the REAR
LEVELING LEG Make sure it fits
securely into the slot See Fig, 1
Fig. 2
B. Mount the ANTI-TIP bracket
with the 4 screws provided as
illustrated in Fig, 2
4