Filter
Top Products
15
ENGLISH
151515
ASSEMBLING YOUR BOWL
-
LIFT
STAND MIXER
Pre-Use Cleaning
Before using your stand mixer for
the first time, wash the mixing bowl
and accessories. See the “Care and
Cleaning“ section.
Attaching Mixing Bowl
1. Make sure the speed control lever
is set to the OFF/0 position.
2. Unplug the stand mixer or
disconnect power.
3. Lower the bowl support by
turning the bowl-lift lever
clockwise.
4. Place bowl brackets over the
locating pins on the bowl support.
5. Press down on the back of the
bowl until bowl pin snaps into
the spring latch.
6. Raise the bowl before mixing.
7. Plug into a grounded
3-prong outlet.
Raising and Lowering Mixing Bowl
1. To raise the bowl, turn the
bowl-lift lever counterclockwise
as far as possible.
2. The bowl-lift lever will snap
into place when the bowl is
completely raised.
3. To lower the bowl, turn the bowl-
lift lever clockwise.
Removing Mixing Bowl
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
WARNING
Lower
Raise
Continued on next page
1. Make sure the speed control
lever is set to the OFF/0
position.
2. Unplug the stand mixer or
disconnect power.
3. Lower the bowl support by
turning the bowl-lift lever
clockwise.
4. Grasp the bowl handle
and lift the bowl off of the
locating pins.