Filter
Top Products
User Guide for the Kyocera K342 Phone 1
1GETTING ST ARTED
Installing the battery
Your Kyocera K342 phone comes with a
removable lithium ion (LiIon) battery.
Fully
charge the battery before using the phone.
You must use a Kyocera-authenticated battery in
your phone. If you attempt to use a battery that has
not been authenticated you will receive a security
warning. Contact your service provider to obtain a
Kyocera-authenticated battery.
To install the battery:
1. Hold the phone
face down.
2. Slide the battery door
downward to remove it.
3. Place the battery in the
phone casing with the
metal contacts facing
towards the bottom of
the phone.
4. Replace the battery door
by sliding the notches into
the openings at the
bottom and outside edges
of the battery casing.
5. Slide the door up to
secure the cover
into place.
Charging the battery
You must have at least a
partial charge
in the battery
to make or receive calls.
To charge the battery:
1. Connect the AC adapter
to the jack on the bottom
of the phone.
2. Plug the adapter into a wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Note: The battery will not charge if you use the
phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Note: To remove the battery, make sure the phone
is powered off.
82-G1673-1EN.book Page 1 Tuesday, August 22, 2006 1:23 PM