Filter
Top Products
Problem Possible cause and remedy
The message "Fault with
moisture control - the
automatic programmes
will operate without
moisture" appears in the
display after selecting
an Automatic
programme.
The steam injection system is faulty.
^
Call the Miele Service Department.
Automatic programmes can be run without using
moisture.
After selecting the
Moisture plus d
function "Fault with
moisture control -
Moisture plus
programme not
available" appears in
the display.
The steam injection system is faulty.
^
Call the Miele Service Department.
^
Use the Fan plus U function instead of the Moisture
plus d function.
Programmes using
moisture will not take in
water.
^ Check whether "On" has been selected for demo
mode (see "Settings - Showroom programme").
The oven can be used in demo mode but the pump for
the steam injection system will not work.
^ Deactivate demo mode.
A noise can be heard
after a cooking process.
The fan remains switched on after a cooking
programme (see "Settings - Cooling fan run-on").
The rack and other
accessories make a
noise when being
pushed into or pulled
out of the oven.
The pyrolytic resistant surface of the side runners
creates friction when accessories are being pushed
into or pulled out of the oven.
To reduce the friction, add a few drops of heat resistant
cooking oil to some kitchen paper and use this to
lubricate the side runners.
Repeat this after each pyrolytic cleaning process.
Problem solving guide
136