Filter
Top Products
Preparing and starting the water
intake process
^
Fill a suitable container with the
required amount of fresh tap water.
^
Open the door.
^
Pull the water intake pipe forwards
(located below the control panel on
the left).
^ Immerse the end of the water intake
pipe in the container with tap water.
^
Touch "OK".
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
The intake process can be
interrupted and restarted at any time
by selecting "Stop" or "Start".
^
Remove the water container after the
water intake process.
^ Confirm the message telling you that
the process is complete with "OK".
^ Close the door.
You will hear the pump briefly as the
remaining water in the water intake tube
is drawn into the oven.
Moisture plus d
70