Filter
Top Products
F Place the container with the
descaling solution together with the
plastic tube on the floor of the oven.
G Attach the other end of the plastic
tube to the water intake pipe.
H Close the door.
I Touch the OK sensor.
The intake process will begin. You can
hear the pump while this is happening.
The intake process can be
interrupted and restarted at any time
by touching OK.
The amount of solution specified can
be more than the amount which is
actually taken in. Some of the solution
may therefore be left in the container at
the end of descaling.
A message will appear in the display
when the intake process is finished.
J Touch the OK sensor.
The activation phase will begin. You
can follow the duration as it counts
down.
K Open the door.
L Leave the container with the tube
connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
M Close the door.
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump for a
moment or so.
At the end of the activation phase a
buzzer will sound, if the buzzer is
switched on (see "Settings - Buzzer
tones").
Cleaning and care
113