Filter
Top Products
When to add the steam
This option will only appear in the
display after you have selected 1, 2
or 3 bursts of steam.
Tip: If you have selected more than one
burst of steam, the 2nd one should be
released at least 10 minutes after
starting the programme.
–
Manual steam
If you want to inject the bursts of steam
manually:
^ Select "Manual steam".
Then set the minute minder N to
remind you when to release them.
– Time-controlled steam
If you want to time when to release the
bursts of steam:
^ Select "Time-controlled steam".
^ Set the time for each burst of steam.
The oven will then release the steam
at the specified times. The time
counts down as soon as the
programme is started.
^
Touch the OK sensor.
The prompt to draw in water then
appears.
Preparing and starting the water
intake process
^
Fill a suitable container with the
required amount of fresh tap water.
^
Open the door.
^
Pull the water intake pipe forwards
(located below the control panel on
the left).
^ Immerse the end of the water intake
pipe in the container with tap water.
^
Touch the OK sensor.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
The water intake process can be
interrupted and restarted at any time
by touching OK.
Moisture plus d
61