Filter
Top Products
Rinsing
To remove any coffee grounds from the system the
water piping and brew unit must be rinsed through
every day before the first drink is prepared. If
programme "Rinsing" is set to "On" rinsing will start
automatically when the machine is cold and the
selector switch is set to the "On" position, with or
without lighting. This will warm the brew unit up at
the same time because hot water is used for the
rinse process. An appropriate message will appear
in the display.
If a drink has just been prepared the machine will
still run an automatic rinse programme shortly
before it goes into standby mode.
To prevent water from running into the
drip tray always place an empty cup
under the coffee spouts before making
the first cup of coffee.
^ Turn the selector anti-clockwise to the
programming position. The machine is now in
programming mode and will respond according to
the symbols shown under the buttons.
The following message will appear in the display:
^
Press the e button to highlight programming
option "Rinsing" with an asterisk.
^
Press ENTER to confirm this option.
The sub-menu will appear in the display as
follows:
Programming the machine
16