Filter
Top Products
^
Place a container, minimum capacity 0.75 litres,
under both coffee spouts.
^
Press the rinsing and pre-warming button e.
(The machine must be operational and heated up,
otherwise it will not react when the buttons are
pressed.)
The following will appear in the display:
^
Press the e button to highlight programming
option "Rinsing cycle" with an asterisk.
^ Press ENTER.
The following will appear in the display:
A small amount of water will run out of the spouts,
then a small pause before requesting the next
amount of water. This procedure is carried out 4
times. On the last rinse about half a litre of water
runs out. The whole procedure takes approx. 5
minutes.
^
At the end of the rinsing cycle, the following will
appear in the display:
The brew unit has now been cleaned of
all residues and cleaning agents. Check
that the joints of the brew unit are still
sufficiently lubricated.
Cleaning and care
55