Filter
Top Products
In the case of severe soiling the pyro-
lytic process is interrupted. Remove
large pieces of debris before starting
the pyrolytic process again.
The end of the pyrolytic process is
shown
– by the "p" symbol flashing, and
– by an audible tone
once the oven has cooled to a tempera-
ture below 280°C and the door lock
has been released.
After the pyrolytic process pyrolytic
debris (e.g, ash), which can build up
according to the level of soiling, can
easily be removed.
Only remove debris when the oven
has cooled. Danger of burning!
Most debris can be removed with a
damp cloth. Depending on the level of
soiling, in certain circumstances a
clearly visible film can build up on the
oven door, on the panel and under the
guard. This can be removed with a
shielded blade scraper or a non-ab-
rasive sponge and a mild solution of
warm water and washing-up liquid.
Spilt fruit juices may cause lasting
discolouration of the surfaces and
roasting can cause matt areas to ap-
pear. This discolouration is perma-
nent but will not affect the efficiency
of the enamel. Do not attempt to
remove these marks.
You can delay the start of the pyro-
lytic process for example, to take
advantage of cheaper night electricity
tarifs.
In order to do this, start the pyrolytic
process and use the "f" button to
delay the start of the process.
As soon as the start delay is taken up,
– "PYRO" goes out in the display
– the "p" symbol lights up.
When the pyrolytic process starts,
"PYRO" lights up in the display.
The pyrolytic process is interrupted,
– if the function selector is turned to
the "0" position.
– if another function is selected during
the pyrolytic process.
– in the event of a power cut.
The oven door remains locked in the
case of an interruption.
The door will only open again when the
oven temperature has fallen below
280°C and the function selector has
been turned to the "0" position and then
to "Light H". The "p" symbol lights up in
the display.
When, after approx. 30 seconds, the "p"
symbol flashes, the door can be opened.
If the heat-up phase of the pyrolytic
process interrupts independently,
the error message "F 15" appears in the
display.
The door will open only when the oven
temperature has fallen below 280 °C
and the function selector has been
turned to the "0" position and then to
"Light H".
After approx. 60 seconds the error
message goes out and "PYRO" and the
"p" symbol light up in the display.
When after approx. 30 seconds, the
"p" symbol flashes, the oven door can be
opened.
Cleaning and care
61