Miele H 383 Convection Oven User Manual


 
The appliance must only be oper
-
ated when it has been built in.
The oven is designed to be built into
a tall unit. If you wish to install it in a
base unit, the stainless steel rail
above the control panel must be re
-
placed by a sealing strip. The seal
-
ing strip offers additional protection
from any liquids that might spill
down from the worktop, and can be
purchased from the Miele Spare
Parts dept.
If the oven is to be built into a base
unit, a cut-out is required in the in-
terim shelf as close as possible to
the wall or unit back panel to ensure
that there is sufficient ventilation for
the appliance.
The length and depth of the cut-out
is not important, as long as cut-out
measures at least 150 cm
2
(see also
"Installing the cooker").
Do not fit insulation material inside
the housing unit. This would hinder
the intake of air to cool the appli
-
ance.
Follow the relevant instructions for your
specific model.
There are particular installation require
-
ments for the H 390 which must be ob
-
served.
Installing an oven
79