Filter
Top Products
Before using for the first time
19
Displaying and setting the water
har
dness level
Open the door
.
T
urn the dishwasher off with the
button, if it is turned on.
Press the program selection button
, and, simultaneously switch the
dishwasher on using the button.
Keep the program selection button
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the
Short butt
on twice.
The Short
indicator light will flash twice
at short intervals.
The value which has been set for the
wat
er hardness appears as a figure in
the time display (see table) according to
.
will star
t flashing in the time display.
This is the factory default setting of 1°.
Use the pr
ogram selection button
to select the value which equates to
your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
T
urn the dishwasher off with the
button.