Miele HG06 Dishwasher User Manual


 
Water connection
71
The Miele WaterProof System
Provided your dishwasher has been in‐
stalled corr
ectly, the Miele WaterProof
System will protect you from water
damage throughout its lifetime.
Water intake
W
ater in the dishwasher must
not be used as drinking water.
The dishwasher may be connected to
a col
d or hot water supply up to a
maximum of 140°F/60°C.
We would only recommend connec‐
tion to a hot water supply if it is eco‐
nomical, e.g. a solar-powered supply.
When connected to a hot water sup‐
ply, all program stages which would
otherwise be carried out with cold
water will be carried out with hot wa‐
ter.
The intake hose is approx. 4' 11"/1.5
m lon
g. A 1.5 m long flexible metal
extension hose (pressure tested to
2,030 psi) is available as an optional
accessory, if required.
A faucet with a 3/4" male thread
must be pr
ovided on site.
This appliance is constructed to
comply with ANSI/ASSE 1001 //
IEC/EN/DIN 61770
// VDE 0700 Part
600, and may be connected to a suit‐
able supply without an extra non-re‐
turn valve if national regulations per‐
mit.
The water pressure (flow pressure at
the tak
e-off point) must be between
4.35 - 145 psi. If the water pressure
is too high, a pressure reducer valve
must be fitted.
After connecting the dishwasher to
the water supply, check that the wa‐
ter intake is airtight.
T
o avoid any damage to the ap‐
pliance, the dishwasher must only be
connected to fully vented pipework.
The intak
e hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).