Filter
Top Products
Options
46
Buzzer tones
A sequence of audible tones will sound
at the end of the pr
ogram or if there is a
fault.
The buzzer at the end of a program and
the warning
buzzer in the event of a
fault will sound 4 times at intervals with
a short pause between each set.
The buzzer tones are set to off at the
fact
ory.
If you want the buzzer to sound at the
end of a program, you will have to
switch it on. Buzzer tones for faults are
always active.
Open the door
.
T
urn the dishwasher off with the
button, if it is turned on.
P
ress the program selection button
, and, simultaneously switch the
dishwasher on using the button.
Keep the program selection button
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the
Short butt
on four times.
The Short
indicator will flash four times
at short intervals.
The flashing sequence in the time dis‐
play shows whether the buzz
ers at the
end of the program are activated or de‐
activated.
– : Buzz
er tones activated
– : Buzz
er tones deactivated
Press the program selection button
to change the setting.
The setting is now stored in memory.
T
urn the dishwasher off with the
button.