Filter
Top Products
Options
47
Optimize Standby
"Optimize Standby" is activated by de‐
fault.
To save energy, the dishwasher will
switch off aut
omatically a few minutes
after the last time a button has been
pressed or after the end of a program.
The dishwasher will not turn off while
a pr
ogram is running, during the delay
start period, or if there is a fault.
Optimize Standby can be switched off if
you pr
efer. If you do this the duration
before the dishwasher switches off au‐
tomatically increases to 6 hours. Doing
this will increase energy consumption.
Open the door
.
T
urn the dishwasher off with the
button, if it is turned on.
P
ress the program selection button
, and, simultaneously switch the
dishwasher on using the button.
Keep the program selection button
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the
Short butt
on eight times.
The Short
indicator light will flash eight
times at short intervals.
The flashing sequence in the display
shows whether or no
t Optimize Stand‐
by is activated.
– : "O
ptimize Standby" activated
– : "O
ptimize Standby" deactivated
P
ress the program selection button
to change the setting.
The setting is now stored in memory.
T
urn the dishwasher off with the
button.