Filter
Top Products
Operation
38
Starting a program
S
tart the program by closing the door
within four seconds of the last press
of a button.
The program will begin.
The Optical Interface comes on to show
that a pr
ogram has been started.
If you do not close the door within
four sec
onds, the indicator light of
the selected program and the time
display will flash.
The program cannot be started until
you
press the program selection but‐
ton and close the door within four
seconds.
A program should only be canceled
in
the first few minutes, if at all. Oth‐
erwise important program stages
could be omitted.
Time display
The duration of the program selected
appears in hours and minu
tes in the
display before the program begins. Dur‐
ing the program, the time left until the
end of the program is displayed.
The program duration displayed may
var
y with the same program. It is influ‐
enced by, among other things, the wa‐
ter temperature at each intake, the re‐
activation process, the type of deter‐
gent, the amount of dishware, and the
amount of soiling.
When a program is selected for the first
time, the display shows an aver
age
time for a cold water intake.
The times shown in the program over‐
view r
efer to standard test loads and
temperatures.
Each time a program is run, the elec‐
tr
onic module calculates the program
duration required according to the tem‐
perature of the water taken into the
dishwasher and the amount of dish‐
ware.