Filter
Top Products
Hob with frame or bevelled edge
55
Installation
Preparing the worktop
Ma
ke the worktop cut-out as shown
in the building-in diagram. Observe
the safety distances (see "Safety dis‐
tances").
Seal the cu
t surfaces with a suitable
sealant to avoid swelling caused by
moisture. The sealant must be heat-
resistant.
Make sure that the sealant does not
co
me into contact with the top of the
worktop.
The seal underneath the hob will hold
it secur
ely in the cut-out. Any gap be‐
tween the frame and worktop will re‐
duce with time.
Connecting the mains connection
cable t
o the appliance
The mains connection cable must
on
ly be connected by a suitably
qualified and competent person.
F
ollow the instructions in the wiring
diagram (see "Electrical connection -
Wiring diagram").
Installing the hob
F
eed the mains connection cable
down through the cut-out.
Pl
ace the hob centrally in the cut-out.
When doing this, make sure that the
seal under the hob sits flush with the
worktop on all sides. This is impor‐
tant to ensure an effective seal all
round.
Do not use sealant (e.g. silicone).
If the seal does not meet the worktop
corr
ectly on the corners, the corner ra‐
dius (≤ R4) can be carefully scribed to
suit.
Co
nnect the hob to the mains.
Check that the hob works.