Filter
Top Products
Setting the water softener for a hard-
ness level of 36 - 70 gr/gal requires
the following two step procedure:
1.
Turn the dishwasher off.
Turn the program selector knob to
the “STOP” position.
Press the “Delay start” and “START”
buttons
at the same time, while turn-
ing the machine on. A “P” and a num-
ber will appear in the time display.
Set the program selector knob to the
“NORMAL 55/130” position. The
number “22” will appear in the time
display.
“22” = The factory setting for a water
hardness of 22 gr/gal.
Press the “Top Solo” button as often
as necessary until the value “36” ap-
pears in the display.
Press the “START” button twice
to store the “36” in memory.
2.
The water hardness selector in the
wash cabinet must be set according to
the following chart.
gr/gal ppm °f
value
for
program
-ming
water
hardness
selector
(Setting)
36-47 650- 850 65- 85 36 4
48-65 860-1170 86-117 36 5
66-70 1190-1260 119-126 36 6 *)
*) factory setting
Example:
The water hardness is 60 gr/gal.
The water hardness selector in the
wash cabinet must be set to 5,
(48 - 65 gr/gal).
Using a screwdriver:
Remove the cover from the water
hardness selector.
Adjust the water hardness selector
as necessary. There will be a click as
each setting is reached.
Do not set the selector on setting 1 - 3.
Replace the cover on the water hard-
ness selector.
Water softener
13