Filter
Top Products
The dishes are not clean.
– The dishes are incorrectly loaded.
– The correct amount of detergent was
not used - see “Program chart”.
– The filters in the wash cabinet are
not clean, or the spray arm jets are
blocked - see “Cleaning and care”.
– The wrong program was selected –
see “Program chart”.
White residue is visible on cutlery
and dishware.
– No salt in the salt reservoir.
– Salt reservoir lid has not been
screwed on properly.
– Not enough rinse aid was used.
Water remains in the dishwasher at
the end of a program.
– The drain hose is kinked or clogged.
– The drain pump or non-return valve
may be blocked - see “Cleaning and
care”.
The “Water Intake” indicator lights
during the “ENERGY SAVER” pro-
gram.
The “ENERGY SAVER” program re-
quires a water supply temperature of at
least 45 °C/115 °F. If the incoming
water is less than this temperature, the
“Water Intake” lamp illuminates (see
also “Program selection”). If your hot
water system has been used recently,
not enough hot water may have been
available to adequately clean the
dishes.
If necessary, repeat the program.
If the “Water Intake” lamp lights again,
select a different program.
Problem solving guide
40