Filter
Top Products
Program chart
Program When to use Detergent
A
1)
B
2)
Compart-
ment
I
(Pre-wash)
Compart-
ment
II
(Main
wash)
Compart-
ment
II
(Main
wash)
Universal Programs
NORMAL
55 °C/130 °F
This program is for
normal everyday loads. 20 % 80% 100 %
NORMAL
65 °C/150 °F
Same as NORMAL 55 °C/130 °F, but at a
higher temperature for
stubborn dried on
particles.
20 % 80 % 100 %
INTENSIVE
55 °C/130 °F
Same as NORMAL 55 °C/130 °F, but with a
preliminary pre-wash for
heavy soiling.
20 % 80 % 100 %
INTENSIVE
65 °C/150 °F
Same as INTENSIVE 55 °C/130 °F, but at a
higher wash temperature for
stubborn dried
on particles and lightly soiled pots and pans.
20 % 80 % 100 %
Special programs
ENERGY SAVER
Only select ENERGY SAVER if the dish-
washer is connected to a hot water supply
(minimum temperature 45 °C/115 °F).
– see chapter "Choosing a program"
20 % 80 % 100 %
POTS & PANS
75 °C/170 °F
For pots, pans and dishware with dried on
particles of food and very heavy soiling.
20 % 100 % 120 %
ECONOMY
55 °C/130 °F
For
half a, normal everyday load, or:
for
full loads with very light soiling (e.g.
coffee cups).
50 %
3)
50 %
3)
CHINA & CRYSTAL
45 °C/115 °F
“Gentle program”, for lightly soiled and
heat sensitive tableware. 50 %
3)
50 %
3)
SHORT
45 °C/115 °F
“Quick program”, for lightly soiled
dishware (e.g. party dishware). 50 %
3)
50 %
3)
RINSE & HOLD For rinsing dishes when a complete cycle
is not needed.
The dispensing method will depend on the type of detergent being used:
A
1)
Use this method for:
– detergents which contain phosphates and chlorine.
Divide the total amount, as shown, between compartment I and compartment II.
B
2)
Use this method for:
– detergent which is chlorine and phosphate free.
– detergent which is chlorine free but contains phosphates.
In this instance the whole amount is placed in compartment II.
3) Use half of the manufacturers recommended amount of detergent.
Program chart
26