Filter
Top Products
3. Installing the control panel.
The control panel and hardware is
packaged separately from the dish-
washer. It should be installed using the
following procedure.
If the GDU decor set is being used,
(to convert an “i” dishwasher to a “U”
version), the spacer bars
i must first
be removed and stored for possible
use in the future, (See the separate in-
structions for installing the GDU
decor set). If the GDU kit is
not being
used, skip the following step.
To remove the spacer bars from the
control panel, place the panel on a
table, printed side up, and gently
push down on the spacer bars at a
point near the bottom of the control
panel. This will release the mounting
bolts from their slots.
Install the necessary spacer bars i
on the control panel.
Place the seal b onto the ventilation
grill.
c
Push the ventilation grill c into the
metal backing plate.
Place the covers d over the push-
button switches.
Install the adapter disc e.
Position the control panel f over the
backing plate and fasten it from the
inside of the door
g using the six
screws provided.
Align and press the program knob
onto its shaft
h.
Dishwasher installation
46