Filter
Top Products
Place the door panel on a flat sur-
face, good side face down, taking
care not to scratch the surface.
Make certain that the bottom of the
panel is closest to you.
Using a pencil, lightly draw a center-
line from top to bottom.
Using the previous measurement,
draw a horizontal line “X” inches
above the bottom of the panel.
Important: Make certain the line drawn
using measurement “X” is located at
what will be the bottom of the panel
when it is attached to the dishwasher.
The mounting bracket is marked in
the middle
A
. Lay the bracket on the
rear side of the door front so that the
mark
A in the middle of the bracket
aligns with the vertical guide line,
and the lower holes of the bracket
are centrally positioned in the hori-
zontal guide line (see illustration).
Use strips of adhesive tape to hold
the bracket in this position.
Mark and drill pilot holes for the
screws using a 3/32" (2.5 mm) drill bit.
Attach the bracket to the panel using
the 4 screws provided.
Double check the location of the
bracket before mounting the panel to
the dishwasher.
Attaching the panel.
Pull the dishwasher out from under
the countertop about 4" (10 cm).
If the dishwasher is installed at the
end of the kitchen cabinets: Pull the
machine out as far as is necessary
to reach the 4 locking screws lo-
cated on the edge of the door.
Attach the panel to the dishwasher
by aligning the bracket tabs with the
slots on the door.
Straighten the panel and lock it into
place by tightening the 2 locking
screws on each edge of the door.
Use the provided caps to plug the
locking screw access holes.
Push the dishwasher back under the
countertop, and proceed to Step 6,
“Adjusting the door springs”.
Dishwasher installation
48