Note
•
If the tank packing is not installed, it may cause the water in the water tank or food in the refrigerator compartment to
freeze.
• Replacement is not usually required for the optical catalyst and lead-cleaning filter. However, it may require
replacement in the following cases.
• When it clogs because something other than water was put in the tank
• When it is damaged • When mold has formed
To purchase a new fi lter, contact the retail store where you purchased the refrigerator.
* If mold forms easily in the certain types of water, clean about 2 or 3 times a week.
Procedures for returning the water supply
pump and tank pipe to their original positions
Assembling the water supply pump Installing the tank pipe
Incorrect assembly may prevent ice from forming, or
increase the operation noise.
27
Before Use
Placing Food Inside
Operation Cleaning TroubleshootingCleaning
Water supply
pump
Tank pipe
Impeller
Lid
Optical
catalyst
and lead-
cleaning fi lter
Cap
Tank
Pipe
Water
supply
pump
Tank
Packing
Rotate
1
Fit the fi lter
into the cap.
4
Rotate and fi x the tab (
) of the
cap into the projection (
) on
the water supply pump.
*
Make sure that the impeller is
inside.
5
Rotate and set the water supply
pump onto the water tank.
2
Fit the lid onto the cap.
3
Attach the impeller onto
the water supply pump.
Remove the
cap while
opening the tab
with your fi nger.
Rotate
Do not use cleaners such as kitchen
detergents (neutral), benzene or
bleach to clean the optical catalyst and
lead-cleaning fi lter.
Doing so may result in odours of the ice.
When setting,
align the triangle
mark on the
tank with the
triangle mark on
the packing and
fully put them
together.
The impeller is made
from a magnet.
Wash it thoroughly
to remove any
foreign objects.
Completed
view
Completed
view
Completed
view
Completed
view
Tank
Packing
Tank pipe
Water supply
pump
Caution
Do not let foreign
objects block the
hole.
1
Insert the tank pipe into the water tank.
2
Connect the tank pipe to the water
supply pump.
* Check that there are
no foreign objects
between the tank pipe
and the water
supply pump.
Tank
Pipe
Water
supply
pump
* Align the triangle
mark on the
bottom of the
water tank with
the triangle mark
on the fi lter and
push in while
making sure that
there is no gap.
Tank pipe, water supply pump, optical catalyst and lead-cleaning fi lter
1
Pull out the tank packing (
)
from the water tank.
2
Pull out the tank pipe (
),
and rotate and remove the water
supply pump (
).
3
Disassemble the parts
and wash them.
4
Return the water supply pump, tank pipe, tank packing to
their original positions.
week
once a
Do not use the following for cleaning.
Items such as sponges or scrubbers that may damage surfaces, or cleaners such as alkaline detergents, scouring powder,
boiling water, petroleum or acid