Mitsubishi Electronics MR-EX655W-N-A Refrigerator User Manual


 
If the door is still tilted after adjustment of the supports
Installing the adjustable
support cover
Fully insert the adjustable support
cover horizontally until it touches the
rear side
.
Adjustment and anchoring
Turn and lower the adjustable supports until they touch the fl oor and
the front casters are raised from the fl oor to fi x the refrigerator.
3
Adjustable
support cover
The adjustable support cover
is stored inside the refrigerator
compartment at shipment.
4
The operation noise gets
louder immediately after
installation.
Immediately after instillation, when:
the weather is hot, the doors are
frequently opened or closed, or
any similar situation; the operation
noise will get louder because the
refrigerator will switch to high-speed
operation to cool with high power.
Preventing doors
from being left ajar
Adjusting a tilted door or unevenness
7
Before Use
Placing Food Inside
Operation Cleaning TroubleshootingBefore Use
Adjust the supports to
make the refrigerator
level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
When installing the refrigerator in
the corner of a room, one of the
rear supports may sink, causing the
refrigerator to tilt. If this happens,
use a caster support or strong board
for adjustment. (Normally, use a
board with a thickness of 2 to 3 mm.)
Adjust the adjustable supports as shown
in the fi gures below.
The right door tilts down
Rotate and lower the
right side
Right
Left
The left door tilts down
Adjustable
support
cover
Adjustable
support
Caster
Rotate and lower the
left side
Rear support
Caster support
or strong board
If the installation
location is not level
or the supports sink
after a few days
of installation due
to the weight of
the food, the doors
may appear tilted.
Readjust the
supports.
* More than 100
kg of food can
be stored in the
refrigerator.
Although fl ammable refrigerant is used, the refrigerant circuit
is hermetically sealed and normally leaks will not occur.
Warning
Should the refrigerant circuit be damaged:
1. Do not use fl ames or electrical appliances nearby.
2. Open the windows to fully ventilate the room.
Then, contact the retail store where you purchased the
refrigerator.
Adjustable
support
Caster
Turn the adjustable
supports in the arrow
direction until they
touch the fl oor.
Adjustable support cover
(To prevent vibration, noise, movement, and doors left ajar)
Bottom front of refrigerator
Prepare for earthquakes
(for areas prone to earthquakes)
Pass 2 strong belts through the hand-holds on the top
rear of therefrigerator and anchor them to a strong
location, such as wall or post.
Strong belts
Do not damage the refrigerant
circuit (pipes) or drive screws into it.
Caution
If the supports are not
adjusted properly,
the refrigerator may
move and cause
injury.
Warning
The refrigerator may tip over
and cause injury.