Filter
Top Products
Chapter 3 – Using the Web Management Software
38 MultiModem rCell User Guide
General Configuration Group
In the General Configuration group , set the general system-based parameters.
Date The system date: MM/DD/YYYY
Time HH:MM:SS. A real time clock is part of SNTP to display proper time.
IP Configuration Group
Use the IP Configuration group to configure the Ethernet interface. If desired see Appendix A for a table of commonly
supported subnets.
IP Address
(Default is 192.168.2.1),
Mask
(Default 255.255.255.0),
Default Gateway
(Default 0.0.0.0),
Primary DNS
(Default 0.0.0.0),
Secondary DNS
(Default 0.0.0.0).
Auto Dial out Configuration Group
Auto Dialout
Check the box to enable or disable Auto Dialout. Default is Enable. The Auto Dialout settings allow you
to use the integrated cellular modem directly with no router functions. This is accomplished using
redirector software on your computer. This software creates a virtual serial port allowing your
computer to communicate with the integrated cellular modem over IP using telnet.
Raw Dialout
Check the box to enable or disable raw mode for an Auto Dialout session. Default is Disable.
Auto Dialout
Login
Check the box to enable or disable Auto Dialout Login feature. Default is Enable. The Auto Dialout port
is the telnet port used by the redirector software on your computer to communicate to the integrated
cellular modem.
Auto Dialout Port
Enter the serial Auto Dialout Port number. Default is 5000.
Handle EIA Signal
Check the box to enable or disable the EIA standard signal characteristics (time and duration) used
between different electronic devices.
Inactivity
Enter the seconds that the auto dialout session stays active before going inactive.
Syslog Configuration Group
Syslog
Check the box to enable or disable Syslog. Default is Disable.
Syslog Server IP
Address
If a Remote Syslog Server IP Address is specified, the syslog feature acts as a remote Syslog.
Auto Discovery Group
Auto Discovery
Check the box to enable or disable Auto Discovery to broadcast (MAC level), the MAC Address, IP
Address, and DHCP information to the configured server port. Default is Enable. The router sends a
broadcast packet on the specified server port every 10 seconds or whatever interval the broadcast
timer is set to.
Server Port
Enter the Server Port Number. Default port is 1020.
Broadcast Timer
Enter the amount of time in seconds for the auto-discovery packet granularity of periodic
broadcasting. Default is 10 seconds.