Filter
Top Products
7. Speed Dial Toil Override Assignment (See Fig. 340-23)
This area of the program is used to permit or deny Toll
Restricted Stations using the System Speed Dial access
numbers 40 - 59 to override toll restriction. This choice
only applies to system speed dial memory access
numbers 40 - 59 and all toll restricted stations on a
system wide basis. Address 16 button 8 is used to allow
or disallow system speed dial buffers 40 - 59 toll over-
ride. The default value is that System Speed Dial will
override toll restriction.
8.
Toll Restriction Override Table (See Fig. 340-24)
This area of the program can be used to enter up to 30
3-digit codes to override *the Toll Restriction. Some
uses for ‘&IS table would be to provide access to
commonservicecodessuchas911,61! and411 andto
allow dialing 800 numbers and selected foreign area
codes. Two addresses are used for each code. The first
four buttons of an odd-numbered address are used to
enter the first digit. The second four buttons are used
to enter the second digit. The first four buttons of the
following even-numbered address are used to enter the
third digit. The numbers are entered in binary with 10
equal to 0 on the dial pad. Any address which is com-
pletely blank (no LEDs lit) is recognized as terminating
the Override Table so no address
can
be skipped when
.
programming. The default value of the Override Table
is that no 3-digit codes are entered.
Page 300 -15